|
|
Ag-Series Standard FeaturesKifco has more than 40 years of experience in the design and manufacture of traveling irrigation machines. The highly efficient turbine motor was developed specifically for the hard hose traveler to operate with both fresh and 'gray' water. These machines are marketed under Kifco's trademark Ag-Rain. Ag-Rain Engine Drive machines are available for applications where the water quality does not permit the use of a turbine. Engine vs. Turbine There are three circumstances that usually dictate the need for engine driven Water-Reels instead of turbine driven Water-Reels. 1. High Travel Speeds. An engine driven model should be used if high travel speeds are needed for light applications (0.3 inches of water or less). Engine driven travelers are capable of speeds two times that of turbine drives. 2. Slurry Application. If the Water-Reel is applying slurry or any substance that contains significant solids, an engine driven model should be used. Usage of a turbine driven model in a slurry application is limited due to the size of particles that can pass through a turbine motor. 3. Marginal Water Pressure. If the pressure of the water is marginal it may be wise to choose an engine driven machine. The turbine driven system will take approximately 6psi to 10 psi to power the turbine depending on the speed of travel. This additional pressure at the sprinkler may be critical. When these three factors are not involved, the turbine driven models are the best choice. The turbine requires less service and attention than the engines. Most operators prefer the operating simplicity of a turbine. There are no oil changes, no gas tanks to fill, and no engines to start. With a turbine driven model, when the pump runs, the turbine runs. When the pump stops; the turbine stops.
Ag-Series Standard Features
4 in. x 30 ft. on 30A, 33A, 37A, & 40A 3 in. x 30 ft. on 23A, 27A, 30AS, & 30A Polyethylene Tube Only PE tube designed and constructed for the constant coiling and dragging is considered for use on Ag-Rain Water-Reels®. The tubing is backed by a 5-year prorated warranty. PE Tube Repair A simple "screw-in" mender is available for repairing the PE tube should it become damaged for any reason. (800) 452-7017 |
|||||
|
Copyright © 2002, Kifco |